PyroBreak EX13 is a water based flame retardant saturant for flame retardant treatment of paper, paperboard, wood or natural fibers. The product contains a wetting agent to increase the rate of penetration. The product is a phosphorous based flame retardant system and is appropriate where salt based flame retardant chemistry cannot be applied.
Weight/gallon: 10.5 ± 0.2 lbs.
Viscosity: < 10 centipoise
Solids: 49.0% ± 1.0%
pH: 7.0 ± 0.2
PyroBreak EX13 is applied by spray, dip, roller, or brush. It imparts excellent flame retardancy to:
NOTE: While PyroBreak EX13 functions extremely well on many materials, it does not provide flame retardancy to every fibrous substrate. The buyer accepts liability for determining whether the product is suitable for the buyer's intended use.
The product is available in 5-gallon pails or 55-gallon drums.
It should not be repackaged without consulting PyroTech.
PyroBreak EX13 should be stored at temperatures above freezing and below 100 F. Should the product freeze, it can be reconstituted by warming gently to 75 F with mixing. At temperatures above 90 F, there may be a slight amount of ammonia gas released. Care should be taken when opening drums as there may be a slight pressure build up.
Wear protective mask, gloves, and safety goggles to avoid potential nasal, throat, skin, or eye irritation while applying the product by spray. While it is non-toxic, the product may cause skin irritation in certain individuals.
Stir PyroBreak EX13 before use to redisperse its components.
DO NOT SHAKE — foaming may result.
Clean all equipment immediately following use with warm water and mild detergent.
PyroBreak PyroBreak EX13 is completely water soluble and, therefore, the application equipment and spills may be cleaned with water.
Clean immediately with an absorbent if PyroBreak EX13 is spilled.
PyroBreak EX13 contains no solvents or hazardous chemical components. The following procedures, though, should be followed when using the product: